• 0

'No Signal' After installation
2 2

Question

Hello guys,

I have installed my Niresh's Maverics but after installation my monitor says 'No Signal' go to sleep mode...
You can see on my video: 



Please, help me...


Gigabyte GTX 560
MSI Z87-G45 Gaming
Intrel core i7 4770k
12GB Ram Kingstone

Share this post


Link to post
Share on other sites

19 answers to this question

  • 0

@David Nedomlel Yes always there is help :)

boot using the installer (USB or DvD the one you used)

Open Terminal and Use these commands (One line at a time )

 

The following command will list the volumes

ls /Volumes 

now make not of your OS X Installed Volume Name Im Assuming it as "Mac" in This case (The name is case-sensitive)

mv /Volumes/"Mac"/System/Library/Extensions/AppleIntel* /Volumes/"Mac"

reboot now

Share this post


Link to post
Share on other sites
  • 0

After typing ls /Volumes Press Enter

Share this post


Link to post
Share on other sites
  • 0

Finally I installed my Maverics 10.9 but now I have problem with graphics. Resolution only 1024x768 and everything is lagging and not smooth. Ethernet dont working too...I am very sad1610069_1479085168992323_891907897850826I hope you will help me @

Share this post


Link to post
Share on other sites
  • 0

Finally I installed my Maverics 10.9 but now I have problem with graphics. Resolution only 1024x768 and everything is lagging and not smooth. Ethernet dont working too...I am very sad -snip- I hope you will help me @

I think that happend because you were in setup mode, the OS was still configuring stuff.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
2 2