• 0

ALC 892 Audio Working With Kext-dev=1 but too much increase in Boot time.
1 1

Question

My ALC892 works just with Voodoo 2.8.6 and only with kext-Dev=1 but if I use Kext-dev=1 it increase my boot time too much. from 17seconds to 1 minute 20 seconds... Without kext-dev=1 it boots normally with good boot time but without sound... what should i do.  Using Clover as boot Loader on YOSEMITE.... ANY Help will be greatly appreciated..

Share this post


Link to post
Share on other sites

2 answers to this question

  • 0

1st of all you are using the wrong bootflag its kext-dev-mode=1 not kext-dev=1 so use it properly

in my view 3 second late is not a big deal @Ibrahim Muslim

Share this post


Link to post
Share on other sites
  • 0

Hoo Sorry. I was using kext-dev-mode=1 not the other one and the delay is from 17 seconds to one minute and 20 seconds not 17seconds to 20 seconds. I used clover for the writing the bootflag. Thanks for your Reply.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
1 1