• 0

Can't boot after Clover Configurator setup


Hey Guyz nice to meet you all,

As the title mentions, I have the following issue after running the clover configurator. 

Specs: Compaq Presario CQ50

Intel core2duo P8400 2.26 and 2Gb Ram.

Nvidia graphics chipset as far as I remember Geforce 9400M. (not sure and cant define as I cant boot)

Well in summary I had successfully install yosemite with Niresh Yosemite Dmg. I chose CLOVER EFI Bootloader and it booted nicely 1st time. 

After that I had some issues with my ethernet (dhcp gained IP but not internet) and thought to run clover configurator to do the clover lan fix (might screw up everything hehe)

At first mounted my EFI partition and open the config.plist so I loaded the whole configuration within clover configurator.

After save and reboot the yosemite partition starts to boot but after almost the half bar of boot I get instant reboot

Booted with the -v flag and attached the photo. I believe is something with my ethernet or applesmbus not sure though im not a pioneer hehe

I would really appreciate any help on top of that as I am newbie :D

THanks in advance guyz 

IMG_0447 [167630].JPG

Share this post

Link to post
Share on other sites

1 answer to this question

  • 0

Figured out the nvidia injection was off in clover now I am back again! INJECT NVIDIA ALL! haha 

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now