I launch the pkg
I change the Install location to the USB drive
I click "Install"
I enter the password for my Mac
Pkg says "Configuring Installation" then jumps to "The Installation Failed"
Wassup with that?
@xW4LK3R Try these in BIOS
Load "UEFI Default Settings"
Change IDE to AHCI
Disable Spread Spectrum and Intel SpeedStep Technology
The following lines were copied from a Forum Post
You should not have any discrete card present during boot or it will kernel panic. Ensure "onboard graphics" is enabled before turning it off and removing the discrete card from your system. Save your UEFI settings exit, turn off your system, remove the discrete card, plug in your HDMI or DVI to HDMI and you should be good to go.