• 0

Help with booting Yosemite without having to enter convoluted code each time
1 1


I'm new to this but have managed to figure out how to install Yosemite onto my computer.

It took hours of reading and problem solving but I eventually managed to install it and run it by booting using this code:


npci=0x3000 PCIRoot=0 PCIRootUID=1 cpus=1 maxmem=2048 USBBusFix=Yes nv_disable=1 GraphicsEnabler=No IGPEnabler=No "Graphics Mode"="1024x768x32@60" UseKernelCache=No


But it seems as though I have to enter this each time I boot in order for it to work. Not to mention how sluggish the computer operates when I do it this way! (The specs way exceed minimum requirements).

Basically, I've got this far but don't know how to go about getting the computer to perform normally.

I apologise in advance for my minuscule knowledge.


Any help is much appreciated,




Share this post

Link to post
Share on other sites

0 answers to this question

There have been no answers to this question yet

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
1 1